Assessed First
Mold Removal & Remediation in Lakewood, WA
Containment, HEPA filtration, and antimicrobial treatment remove mold colonies at the source and stop cross-contamination through the rest of the home. Mold remediation removes affected porous materials and corrects the moisture source that allowed growth. The work is done under containment with HEPA filtration so spores are not carried into unaffected rooms, and the area is cleared only once the underlying moisture problem has been resolved.
Remediation is the step after the assessment, not before it. A local pro establishes how far the growth extends and what is feeding it, because removing what is visible while the moisture source is still running puts the same colony back in the same wall. Texas and several other states also set a square-footage point above which the work has to be done by a licensed remediator — the service note below covers where that line falls in this city.
Every pro in our network is licensed and insured in Washington.
Frequently asked questions
The lot is sand. Should that not drain?
Sand drains until it hits a perched layer or a lake. Around American Lake the water table is the lake, and November rain has nowhere lower to go. A crawlspace over that sand is sitting in a wet climate even in a week without a storm. Closing the vents to save heat then traps what the ground is already adding.
Clover Creek looks like a ditch. When does it matter?
When November and a high lake stack. The channel is small for the outwash trough it drains, and a few days of rain put it out of bank onto lots that were platted as upland. The water does not have to be deep; it only has to reach a crawlspace vent.
We sit above the Chambers Creek ravine. Are we clear?
Of the ravine as a flood, yes. Of the path the water takes to get there, no. Outwash above the cut still weeps toward it through the sand, and a crawlspace on that path wets from the side. Being above the gorge is not the same as being off the drainage.