Serving Naples
Structural Drying & Dehumidification in Naples, FL
Commercial dehumidifiers and air movers remove moisture from the structure, with daily readings logged from the material itself for claim documentation. Structural drying brings building materials back to a documented dry standard using air movers and dehumidifiers rather than surface evaporation alone. Moisture readings are logged through the process so the substrate, not just the surface, is confirmed dry before anything is rebuilt.
Frequently asked questions
Our neighbor stayed dry and we did not. Same street, same age of house.
Fill elevation is usually the answer. Lots here were built up at different times and to different standards, and a foot of difference decides where a sheet goes. Construction type rarely explains it, because most of the older stock is the same block on the same sand. A survey of finished floor elevations against the crown of the street tells you which house is the low point, and that is the house that keeps taking water.
Should salt water be handled differently from rain that got in?
Yes. Salt does not evaporate with the water; it stays in the block and the finishes and keeps drawing moisture back long after the meter says the assembly is dry. Rinsing and testing affected surfaces is part of the job, and materials that held salt water for any length of time usually come out rather than get dried. Treating a surge event as a large rain event is the most common way this goes wrong.
The tile floor still looks dry. Do we need to open anything up?
Probably, because tile hides more than it shows. Set over a slab, it lets water pass at the grout and travel under the field, and the surface can look untouched while the setting bed and the wall plates are wet. A meter reading at the slab and in the bottom course of block gives an honest answer. If those read dry, the tile can stay; if they do not, opening a small area early avoids opening a large one later.
This FAQ belongs to the Naples page; it is repeated here.