Serving Schaumburg
Groundwater & Basement Water Intrusion in Schaumburg, IL
Basement seepage, failed sumps, and hydrostatic pressure against the foundation are extracted and dried, and the path from the ground is identified so the loss does not repeat. Groundwater and basement seepage are extracted and dried only after the path from the soil is identified — a wall, a slab, a drain, or a failed sump. Drying the interior without stopping that path returns the same water to the same floor.
Frequently asked questions
Why did the whole street flood at once?
Because the constraint is downstream of every house on it. When the creek rises, the storm sewer that serves the subdivision loses the ability to discharge, and the whole system backs up together. Nothing about any individual lot changes that. It also means response times stretch, since every affected house is calling at the same time, and it is worth knowing which of your neighbors already has a contractor on site.
Our foundation was fine for forty years. Why now?
Older walls here were typically sealed with an applied coating rather than protected by a drainage layer, and coatings age. As the coating loses continuity, the wall relies on the soil staying drier than the concrete, which holds until a wet spring raises the table against it. Nothing failed suddenly; a margin that had been shrinking for years finally ran out. The remedy is usually exterior drainage rather than another coating.
The basement was finished in the 1990s. Does that change anything?
It changes what is at risk rather than how the water arrives. A basement finished decades after it was poured almost never had drain tile added underneath, so the same wall that used to weep onto bare concrete now weeps behind drywall and framing where nobody sees it. Water shows up late and further along than it would have on an unfinished wall, which is why metering behind the finish matters more here than looking at the floor.
The same questions, in context, on the Schaumburg mold removal page.