24/7 Emergency
Storm & Flood Damage Recovery in Aberdeen, SD
From wind-driven rain to flash flooding, local professionals secure the property, extract standing water, dry the structure, and document all damage for the claim. Interior and exterior stabilization is handled to prevent secondary losses. Storm and flood recovery starts with protecting the opening that let water in, then extraction and structural drying, then documenting the loss. Because floodwater carries soil and debris, affected porous materials are removed rather than dried, and the structure is re-checked as it dries.
Frequently asked questions
Water has stood in the low ground for weeks.
Those shallow basins have no outlet, so water collects and leaves only by soaking slowly into clay or by evaporating, which takes weeks. It is a feature of the landscape rather than a failure of anything. A drain helps only if somewhere lower will accept the water, and on ground this flat there frequently is nowhere. Keeping the basin away from the building is the practical response.
The pump is working and the level in the pit will not drop.
That is almost always a frozen discharge line. The pump pushes into a blocked pipe and the water returns, destroying the pump while the basement fills behind it. The cure is in the line rather than the pump: enough fall to empty between cycles, an outlet kept clear of drifted snow, and a relief fitting that gives blocked water another route out.
Under four inches in the wettest month. Why is water an issue?
Because almost none of it can leave. Lake bed clay is close to impermeable and there is no gradient, so what falls stays on or near the surface until it evaporates. Add a winter of snow released over a fortnight onto frozen ground and the ordinary annual figure becomes irrelevant. Rainfall totals here are a poor guide to what a foundation actually experiences.
These questions come from the Aberdeen page.